Two hobbit doors have been placed in tress. One by my house and the other at Hanes Park. No one has stolen them after a week. People do pick them up and move them.
Author Archives: My Project Expert
Hobbit Doors
Back to painting. At first it was keyboards. Now its hobbit doors for the garden and home.
OctoPrint Case for 3D
I finally got around found a case for my raspberry pi 4 running OctoPrint and controlling my 3d printer remotely. Plus check the status of the print and watch video of the 3d Print progress. My biggest issue was determining a way to attach to the printer itself. For past six months, its be justContinue reading “OctoPrint Case for 3D”
Painting Keyboards
Painting keyboards! Who what of thought that would be fun. Here is one of my first one. Went to Goodwill and found cheap and working keyboards. Pulled of the keys. Tapes and spray painted areas. Put dots over the key symbols.
Eggy in the Basket
Eggy in the basket is my favorite breakfast food. I may be the butter and bread that makes it so good
My Toilet is Smoking
My Toilet is Smoking! My Toilet is Smoking! Many don’t people it until they see it!!!!!
SDR-RTL on RPi4
Setting up SDR-RTL on Raspberry Pi 4 was quite easy. Installed CubicSDR Attach SDR-RTL USB device to RPi4 Start with menu at Other>>CubicSDR or from terminal CubicSDR I had a little trouble with getting the sound thru the speakers. Basically on the CubicSDR, the audio being routed to HDMI verse Analog. Also note, that IContinue reading “SDR-RTL on RPi4”
Kismet running on NetHunter
Kismet can be found running WarDriving up under Nethunter app, however it also needs an external wifi adapter to run well. Attaching a USBadapter dongle, I was able to use the ALFA AWUS036ACS. From a command prompt airmon-ng apt-get install firmware-atheros # this not be required ifconfig wlan1 up ip link set wlan1 up airmon-ngContinue reading “Kismet running on NetHunter”
New Stand Using Base from Office Chair
Recently found old abandon office desk chair and removed chair. Stuck PCB pip into base and attach to Inmoov. Now I can roll the robot around as needed.
Replaced my Samsung Screen
Real excited about fixing my Samsung JV7 screen. Purchase a screen for $30 and had it working and about an hour later it quit. Looked closer at it using a microscope and found solder floating in site. The pic shows the pages that broke off. Red shows the broken pads and yellow lines show padsContinue reading “Replaced my Samsung Screen”