3DPRINTED – iot2z

Gradient Descent Model

My first attempt of building a gradient descent model using OpenSCAD.

Planted 2 Hobbit Doors

Two hobbit doors have been placed in tress. One by my house and the other at Hanes Park. No one has stolen them after a week. People do pick them up and move them.

Hobbit Doors

Back to painting. At first it was keyboards. Now its hobbit doors for the garden and home.

I finally got around found a case for my raspberry pi 4 running OctoPrint and controlling my 3d printer remotely. Plus check the status of the print and watch video of the 3d Print progress. My biggest issue was determining a way to attach to the printer itself. For past six months, its be justContinue reading “OctoPrint Case for 3D”

New Stand Using Base from Office Chair

Recently found old abandon office desk chair and removed chair. Stuck PCB pip into base and attach to Inmoov. Now I can roll the robot around as needed.

First Layer Weirdness

While printing my first layer on a 3D print, I notice that the left side was printing with a different pattern. It’s strange that its a perfect rectangle within the first layer. What could cause this? Leveling, gcode, temperature? For strange to me.

First Published Model on Thingiverse

This month I published my first 3D model on Thingiverse. The problem with many of the Inmoov head stands is that they would not hold upright and when testing the movement of head, left and right, the head fell over. The Inmoov head stand has a wide base to prevent this and by inserting theContinue reading “First Published Model on Thingiverse”

PLA Clogged in Extruder

Recently the PLA was clogged in the extruder. It started with clicking sound and rather than fixing it immediately, I thought I would wait. It’s believed it was caused by changing the PLA from HatchBox to eSUN. eSUN used a higher temperature and when it was set to 225 the clicking stopped. Later replaced withContinue reading “PLA Clogged in Extruder”

Building Right Leg of Inmoov

After about 80 hours of printing during the month of December, the right leg is completed. Printing was not so bad, however the toughest part was finding the right screws and bolts for holding it together. Deciding to make it a static leg, which means, it does not have any motors and automated movement. LaterContinue reading “Building Right Leg of Inmoov”

Thingiverse Inmoov Skull Stand

Posted my first design 3D print design on Thingiverse.com. It’s a Inmoov Head stand. Inmoov Head Stand by MyProjectExpert – Thingiverse. The stand solves several issues. First, the current stands don’t hold the head up straight; this design allow the Inmoov head to be better displayed on shelf. Second when tuning and testing the headContinue reading “Thingiverse Inmoov Skull Stand”